Content ID


Strip-Till Merges Tillage and No-Till Benefits

If you’re looking to merge the conservation and soil health aspects of no-till while preserving the soil warm-up perks of conventional tillage, strip-till may be for you. 

Under strip-till, farmers till narrow 6- to 12-inch-wide strips between rows. Fertilizer is often injected into the strip during strip-tilling. Tilled strips correspond to planter row widths of the next crop. The following spring, seed is planted into the tilled strips. Farmers normally strip-till in fall after harvest, but it can be done in the spring before planting. 

University of Minnesota (U of M) and North Dakota State University (NDSU) soil scientists say strip-till does five things: 

  1. Conserves energy and fuel because only partial tillage occurs. 
  2. Reduces soil erosion. That’s because crop residue covers most of the soil throughout the year. The residue blanket also conserves soil moisture. 
  3. Releases less carbon into the atmosphere and maintains higher levels of soil organic matter.
  4. Warms the tilled strips sooner in the spring to promote seed germination and plant emergence.
  5. Reduces expenses by eliminating some primary and secondary tillage.

What’s the Yield Impact?

If you’re looking at the monetary impact of strip-till, look at return on investment via reduced fuel and machinery costs rather than a yield spike. 

Soybean yields in a corn-soybean rotation have been similar among the following systems over 13 years of U of M trials:



Vertical-till (two passes)

Field cultivation (one pass in the spring)

Chisel plow with field cultivation  

Mixed findings have occurred with corn. Overall, corn yields have been similar regardless of which tillage (or no-till) system was used, says Jodi DeJong-Hughes, U of M Extension crops educator.

For corn-on-corn, though, tillage made a positive difference. 

“In the third year of the corn, when residue builds up on the soil surface, that’s when we started seeing yield differences,” says DeJong-Hughes. It’s then when some form of tillage – such as strip-till and chisel plowing – cleared the residue that was dragging down yields. 

Strip-till corn has yielded both above and below yields of soil that’s been chisel plowed or vertically tilled in NDSU trials. However, extenuating circumstances are often involved when lower strip-till yields have occurred. 

In a 2015 NDSU trial, 200-bushel corn yields in a corn-soybean rotation occurred across multiple tillage systems, says Aaron Daigh, NDSU soil scientist. 

“There were no yield differences among any tillage options, except for one set of strip-till plots that yielded 7 bushels less than the rest,” he says. 

In this case, all other tillage systems were planted during good weather. However, rain delayed planting the strip-till plot set. 

“When we finally got in, it was wetter than we wanted, so we got some smearing in it when we did the tillage,” says Daigh. “The yields were hurt from tilling while the soil was too wet.”

Read more about

Crop Talk