You are here

Easy Wire Fencing Unwinding

I made this high-tensile wire unwinder from two disk opener blades, some square tubing, flat stock, bolts, and springs. It is lighter, sturdier, and less expensive than commercial units. Adjust the tension by tightening the center bolt locknut. To change spools, simply turn the tabs inward or loosen the four bolts slightly to slide them in or out for different size rolls.

Tom Block of Pearl City, Illinois

Read more about

Tip of the Day

Tech Tip: Test Used Technology ASAP 

When you buy a used item, whomever you buy it from will, in general, be fair with you. “However, if you buy an item and are not going to... read more