You are here

One place for all tire irons

My tire irons were getting left all over the shop, and I’d had enough of having to go look for them when it was time to start work on a tire. So I built this holder for them with simple materials. I cut 1¾-inch- and 2 ½-inch-diameter pipes into 15-inch-long pieces. Then I welded them to a length of 21-inch tubing. 

Jordan Waldner of Blanchard, North Dakota

Read more about

Tip of the Day

Farmer-Built Tough Trough

one tough trough My new troughs are made of 36-inch drain pipe cut in half. The one in the barn is installed with 6-inch wood screws, flat washers, and... read more